Half Duplex
Written on 9:36 AM by ooe
- It uses only one wire pair with a digital signal running in both directions on the wire.
- It also uses the CSMA/CD protocol to help prevent collisions and to permit retransmitting if a collision does occur.
- If a hub is attached to a switch, it must operate in half-duplex mode because the end stations must be able to detect collisions.
- Half-duplex Ethernet—typically 10BaseT—is only about 30 to 40 percent efficient because a large 10BaseT network will usually only give you 3 to 4Mbps—at most.